Upgraded chassis and bulkhead fitting Spyder RM

I received the new chassis, bulkhead and front bumper for the Spyder RM car, the chassis had never broken for me but I thought I would replace anyway.

It is a 20 minute job to replace them all so I thought I would just do a few photos to show you with a description.

The parts just seem to be a stronger material and no other differences that I can tell, my bumper was broken as you can see from the images.

Electrics:

First remove battery clamp and retaining nuts and screws, then remove sticky pads from your speed controller and receiver. Remove the antenna and retaining grub screw.

Front of chassis:

Step 1: unscrew 2 screws from front bulkhead

Step 2: unscrew 6 screws from underneath (2 for servo and 4 for bulkhead and bumper.)

Attach to new chassis, front done.

Rear of chassis:

Step 1: remove 2 screws from front of rear bulkhead

Step 2: remove 4 screws from underneath

Reattach to new chassis, rear done chassis finished.

Replacing front bulkhead:

I did this after doing chassis replacement.

Step 1 remove two front tie rods and spacers

Step 2: remove shock tower screws x 4

Step 3: remove front bumper screws x 2

Step 4: remove hidden screw underneath which screws into bulkhead and has the little grub screw to remove.

Step 5: fit new bulkhead and bumper.