Fitting RRS System to ERYX 3 and Chassis Stiffener

I wanted to try the RRS System for the ERYX 3.0 (401618). So I ordered a set and here are some pictures which show the putting together and install, also at the same time I fitted the Alu Chassis Stiffener 401617. I also added the light alu screw set to the car and with the addition of stiffener, RRS and screws my car was actually lighter than before by 6 grams so nice result 🙂

RRS System tip:

Tip 1: When fitting the system there are two tiny grub screws which need to be fitted underneath the C hub, see picture below.

Reactive Rear Steering and Chassis Stiffener 34

Tip 2: Also when fitting the steering blocks, there is a way they should be fitted. The webbing top and bottom is shallower on the top, make sure this is the way you fit them.

Reactive Rear Steering and Chassis Stiffener 41

Chassis Stiffener:

The original antenna holder does not seem to work with this, in itself that is no problem, but I wanted to keep the battery stay to stop slop and rubbing the belt. Easy to fix just cut the antenna holder part of the part and fit the base. (I do not use an antenna tube like most people so this is why it is not an issue to cut. Reactive Rear Steering and Chassis Stiffener 32 Reactive Rear Steering and Chassis Stiffener 33

Here is the install gallery for both to give ideas as to how it goes together.